build a simple but awesome BONG, from cheap materials bought from the
"Home Depot" or an other building center's PLUMBING section.
* {'}means foot, {"} means inches

*what materials you need to buy:
- 3' length of 2" ABS pipe.(main body of the bong)
- 1- 2" ABS cap(bottom of the bong)
- 1 12"x3/8" rigid supply line-(tube) water line- for a sink
- 1 1/2" x 3/8" threaded chrome adapter(use as a bowl)
- small can of ABS glue
- hot glue stick
- 3/8' drill bit

*what tools you need:
- a drill, or something that can make 2- 3/8" holes
- pliers or wrench
- hack saw or
- wood saw
-hot glue gun or fire to soften the glue stick

*what to do:
#1- cut 1' off the 3' section of 2" ABS pipe, so you have a 2' length of pipe. discard the 1' left over section.
#2- Glue on the 2" ABS cap, to one end of the 2' section of pipe- which is now the bottom of your bong.
#3- measure 12" from the bottom of your bong, and drill a 3/8" hole at a sharp angle towards the bottom of the bong.
#4- ream out the hole out so the drill bit fits loosely in the hole.
#5- drill one more hole 16" from the bottom, just above the first hole- to make a "choke"
#6- using the nut supplied with the 1/2"x3/8" adapter, insert the 3/8" tube into the adapter and tighten the nut with pliers or wrench.
#7- insert the 12" tube(with the adapter end up) into the hole, leaving 2" of chrome pipe exposed
#8- use hot glue to seal around the 3/8" hole and the 3/8" tube for an air tight seal.
#9- fill with 10" of water, insert a screen into the bowl and fill with your favourite tobacco product and enjoy!

decorate your bong with cool stickers.